CN
Find here details of Vertical Double Bender on our website. Today we would like to talk about how to avoid failures in daily use of pipe bending machine.
Today, with the development of science and technology, China’s pipe bending machine equipment is now mature and stable in terms of quality and technology for pipe bending machines such as hydraulic pipe bending machines and fully automatic pipe bending machines and pipe cutting machines and pipe shrinking machines. It is not like the birth of a new product and new technology in the past, we are all in a state of exploration, so the performance of the machine is relatively fragile, but today’s pipe processing equipment is stable and regular, so As long as you carefully maintain the machine after purchasing the machine, it can be used for a long time.
But what problems often arise in the daily use of elbow opportunities? As a Vertical Double Bender Factory, we can tell you that these problems have also been mentioned in the previous log technical articles. Today we are talking about the old saying, there are usually hydraulic areas where problems occur. Because the machine is bent, the pipe will be cut with a metal circular saw. Small iron pin. If these iron pins are not cleaned, they will be directly processed into the bending machine to process the elbows. Many of the bending machine molds have a core rod to bend, because the fullness is not high enough, so there will be wrinkles or collapse.
In this way, when the pipe bender inserts the pipe into the mandrel, the small iron pins will fall out, and the iron pin that has not been cleaned will fall into the fuel tank inside the fuselage. We all know that the hydraulic pipe bender uses the oil pump input hydraulic pressure. The oil is powered by a solenoid valve. Therefore, most of these iron pins will be filtered by the filter inside the oil inlet pipe after entering the fuel tank, but a small part of the iron pin will enter the oil pump, so that the iron pin sucked into the oil pump will enter the electromagnetic pump. Inside the valve, these iron pins are blocked by the hydraulic solenoid valve because they cannot flow in the solenoid valve, and the hydraulic oil cannot flow, so that a corresponding malfunction occurs, and the hydraulic pipe bending machine cannot work normally.
Even if this phenomenon occurs, there is no need to panic. Just press a button on the control panel to manually press a certain action, then look at the indicator on the solenoid valve to see which solenoid valve is not working, and then turn off the movie. Then use a 4mm Allen key to remove the solenoid valve attached to the oil separator. After cleaning the solenoid valve with clean kerosene, blow the inside with an air gun to clean the iron pin inside, and then install it to solve it.
We also have Highway Vertical Double Bender. If you need any information about it, feel free to contact us.
