CN
Any equipment will have a relevant service life. Once the time is up, failure problems will inevitably occur. Of course, the stirrup bender is also in the process of use. The occurrence of failure problems not only delays production efficiency, but also brings more to the enterprise. Maintenance costs, so for some smaller failure problems, we can choose to learn related solutions to reduce the economic expenditure of stirrup bender, so what are the failures that will occur during the use of stirrup bender? Below Precision Stirrup Bending Machine Manufacturer will come to tell you.
1. Motor failure
If the machine cannot be turned on, it will not operate correctly, or the motor will not be shaken, there is no response, or it suddenly stops after starting. There are two similar situations. There are two processing and reasoning methods. Replace the motor or use professional testing. tool. Then check whether the transmission components are stuck when the steel coiling machine is working.
2. Control system failure
Stirrup Bender can operate normally, but the processing accuracy cannot be guaranteed, and there are often deviations. We can habitually see whether the running parts are loose. Sometimes there will be abnormal noise from the left and right turn keys, or it cannot be classified in the normal way. It is likely that the components are loose or damaged. If the shearing machine equipment fails to effectively cut during the halving process, this needs Understand whether the travel limit switch set by the shearing machine can easily run the eccentric wheel and other equipment.
3. Stirrup Bender is difficult to start
The failure of the bending machine to start is generally a problem with the circuit. First, check the motor and oil pump, if they are working properly, then check the valve block. If they do not turn, they need to check the related electrical appliances. The specific detection methods are as follows:
(1) The sound is flat during operation. If there is noise in the shear, it should be stopped for inspection;
(2) When Stirrup Bender is in operation, the fuel tank will be turned off when the temperature exceeds 60 degrees;
(3) Ensure that under normal circumstances, the machine is started to run idly for several cycles. The test shear is not the same thickness as the sheet, from thin to thick. Ensure users understand the function of bending machine;
(4) Start the bending machine to make several idle cycles, to ensure that under normal circumstances, the test shears are not the same thickness of the sheet, from thin to thick;
(5) Stirrup Bender turns on the pressure gauge switch during the shearing process, and observes the pressure value of the oil circuit. The pressure should be less than 20MPa when cutting the 12mm plate. The remote pressure regulating valve No9 has a pressure setting of 20-22 MPa at the factory. The user must abide by this regulation and must not adjust the pressure for shearing beyond the specified material surface, causing mechanical damage.
The above content is about the malfunction problem that stirrup bender will appear during use. Hope it helps everyone.
