CN
We can see the Automatic Stirrup Bender Machine at every large construction site, so what exactly makes the automatic stirrup bender more and more popular?
We all know that today’s society is developing very quickly, and no matter what industry needs to keep up with the pace of development during the period. Similarly, the construction site must be qualitative in both task efficiency and project quality. The key to bending steel bars, if the task efficiency cannot keep up, will seriously affect the progress of the entire project. And the automatic stirrup pipe bender just handles this difficulty, it plays a role in encouraging the bending rate of the steel bar, and with the advancement of scientific skills, the skills of the automatic stirrup pipe bender also advance from time to time.
At the same time, in the case of building construction, some sports scaffolding made of steel control is often used. However, if it is used excessively in the construction process, it will cause a large number of steel pipes to bend. If the hoop machine is not used for fair repair at this time, I am afraid that it will not guarantee normal operation in the future. Relying solely on manual tricks to implement repairs will only consume unnecessary labor and cause inadvertent injury to staff. Because of the use of a pipe bender, a straightening machine can be used for curved steel pipes, and the surface can also be rusted.
Automatic stirrup pipe bender is an automatic device that can realize the straightening and bending of steel bars. After the reinforcement is formed, it is cut. This completes the process. Failure to cut the rebar will affect use. So what can happen to the automatic stirrup pipe bender? The following Low Speed Straightening Cutting Machine Manufacturer will come to tell you.
In the process of use, if the automatic stirrup bender continuously cuts, it will affect the normal processing and use, and it needs to be processed immediately. The reasons for this are as follows:
1. The cutting blade of the automatic stirrup pipe bender may be worn or damaged and needs to be replaced again;
2. The gap between the scissors of the automatic stirrup bending machine may be too large. It is recommended to adjust the compression bolts.
3. The motor belt of the automatic stirrup bending machine is loose and slipping, and the belt needs to be replaced;
4. The rebar diameter is too large, the motor power is insufficient or the cutter head is not sharp enough;
5. It may also be a poor power supply contact, or only high voltage electricity should be used to generate low power.
6. If the automatic rebar alignment and cutting machine does not produce a knife at all, it may be due to the wrong length setting or the rebar diameter is too small, which causes the rebar alignment and cutting machine to fail to cut.
In addition, how much do you know about the daily use and safe operation of the automatic stirrup bender? The following Rebar Shear-Line Manufacturer has compiled some safe operating practices for your reference.
1. It is forbidden to hold both ends of the steel bar with both hands, and only hold one end of the steel bar with both hands.
2. When using a cutting machine to cut low-alloy steel bars, replace high-hardness blades.
3. If the cutter blade is found abnormal, it should be cut off immediately for maintenance.
4. When using a cutting machine to cut short materials, the length of the end of the hand should not be less than 40cm, and the distance between the hand and the blade near the blade should be kept above 15cm.
5. There should be enough steel bar stacking area around the steel bar straightening and cutting machine.
6. Check whether the blade of the straightener is cracked and whether the blade fixing screw is tightened.
7. During the straightening and cutting machine operation, it is strictly forbidden to clean the sundries near the knife edge by hand.
The above will be the common sense of automatic stirrup bending machine, I hope to help everyone.
