CN
Automatic Stirrup Bender is now generally used in major road and bridge companies, private construction sites, prestressed component factories and other locations. It can be used not only for production lines such as mesh and beams for building reinforcement, but also for straightening and cutting of reinforcement. In the traditional reinforced bending hoop, manual operation is required, which not only has low efficiency, but also produces length and angle deviations in the produced hoop, and it also has hidden dangers in operation and production. These are all people who need some experience to perform an operation! However, the current CNC rebar bending machine has a lot of reduced requirements for workers’ operation, and it only needs one day of training to operate well. The previous type will not occur because Improper operation will cause the quality of the reinforcing bar to decline, which will solve the problem of slow progress of construction projects and so on!
CNC bending hoop machine performance characteristics: design, solid and reliable, compact structure, convenient operation and control, durable, stable performance; especially using thick steel plate, high rigidity round wire rod, high-power medium-speed motor, more stable quality.
The Rebar Shear-Line Factory introduces the things you should pay attention to when operating the automatic stirrup bender.
1. Rebar bending hoop machine belongs to the improvement of the structure of steel bar bending machine. The utility model comprises a speed reducer, a large gear, a small gear, and a curved disk surface, and is characterized in that in the structure: a two-stage brake motor is directly connected to the speed reducer; the small gear and the large gear are meshed for two-stage speed reduction; the large gear is always driven The curved disk surface rotates; a shaft hole and a plurality of curved shaft holes are provided on the curved disk surface; a plurality of positioning shaft holes are respectively provided on the positioning square bars of the worktable surface. Because the two-stage brake motor is directly connected with the reducer for deceleration, the ratio of input and output revolutions is accurate, and the bending speed is stable and accurate. The speed can be changed automatically by using electric control, and the brake can ensure the bending angle. Use the forward and reverse rotation of the motor to bend the rebar in both directions.
2. Install the mandrel, forming shaft, iron shaft or variable bracket according to the diameter of the processing steel bar and the requirements of the bending machine.
3. Check the mandrel, stoppers and turntables for damage and cracks. , The protective cover is fastened and reliable, and can be operated only after confirming the normal operation of the empty machine.
4. During operation, insert one end of the steel bar that needs to be bent into the gap provided by the turntable, and the other end should be fixed against the fuselage and pressed by hand. Check the fuselage to ensure that it is installed on the side that blocks the steel bar.
5. During the operation, it is strictly forbidden to replace the mandrel, change the angle, and adjust the speed, and do not refuel or remove it.
6. When bending steel bars, it is strictly forbidden to process the steel bar diameter, the number of bars and the mechanical speed exceeding the mechanical requirements.
7. When bending high-hardness or low-alloy steel bars, the diameter should be changed according to the specifications on the mechanical nameplate, and the corresponding mandrel should be replaced.
8. It is strictly forbidden to stand within the working radius of the bending steel bar and the side where the fuselage is not fixed. The bent semi-finished products should be stacked neatly. 9. When the turntable is changed over, it should be stopped after it is stable.
10. After the operation is completed, the site is cleaned, the machinery is maintained, and the power lock box is cut off.
The above is the introduction of Low Speed Straightening Cutting Machine Manufacturer, I hope to help everyone.
