CN
Before using CNC rebar bending centers, we introduced many things to pay attention to. Good operating habits and matters needing attention can extend the life of CNC rebar bending centers. So what should we pay attention to when using CNC rebar bending centers? Next, Precision Machining Stirrup Bender Supplier will tell you.
1. When processing steel, the predetermined diameter of machine steel processing and the number of machine speeds should not be exceeded. Reinforcement cage roll welding machine According to the construction requirements, the main reinforcement of the reinforcement cage is manually fixed through the corresponding template circular hole of the fixed rotary disk to the corresponding hole of the mobile rotary disk. Then, the fixed revolving disk and the moving revolving disk are rotated to wind the rebar around the main rib (the moving disk is rotated while moving backward), and welding is performed at the same time to form a product reinforcement cage. Reinforced cage roll welding machine has a fast processing speed: under normal circumstances, 5 people work in one batch and the work is divided into two shifts. 10 people can process more than 20 12-meter-long finished cages in one day Installation of ribs, installation of detection tubes, installation of guide pads, etc.), the work efficiency is very high.
2. During the machining process, the bending center of CNC steel bars is strictly forbidden to work on one side of the working radius and the body without fixed pins. After the bending steel bars are processed, they should be neatly stacked and the hooks must not face upwards.
3. The workbench and workbench of the C should be kept in a horizontal position. Before operation, check the NC bending center of the core shaft, the forming shaft, the iron guard shaft, and the variable guard for cracks or damage. The protective layer is solid and reliable. Check that the machine is running properly before processing the rod.
4. During non-replacement of the mandrel and forming the shaft during the cleaning operation, change the angle and speed, fuel or prohibit the bending machine during operation.
5. Familiar with the reverse switch to control the direction of rotation of the forehead of the work board. Rebar should be placed in the direction of rotation of the gears and work plates, and must not be inverted.
6. If the direction of the work plate needs to be changed after stopping, that is, from forward rotation to stop-reverse rotation, it is not allowed to directly rotate from forward rotation to reverse rotation or vice versa.
Please note that the operation of the CNC Rebar Bending Center described in the above information is focused on avoiding bending down of the CNC steel center when talking about the above problems in use, affecting the use.
