CN
Before using CNC rebar bending centers, we introduced many things to pay attention to. Good operating habits and matters needing attention can prolong the service life of CNC rebar bending centers, so what should we pay attention to when using CNC rebar bending centers? The High Precision Stirrup Bending Machine Factory will tell you next.
When processing steel, the predetermined diameter of the machine steel processing and the amount of machine speed should not be exceeded. Reinforcement cage roll welding machine According to the construction requirements, the main reinforcement of the reinforcement cage is manually fixed through the corresponding template circular hole of the fixed rotary disk to the corresponding hole of the mobile rotary disk. Then, the fixed revolving disk and the moving revolving disk are rotated to wind the rebar around the main rib (the moving disk is rotated while moving backward), and welding is performed at the same time to form a product reinforcement cage. Reinforced cage roll welding machine has a fast processing speed: under normal circumstances, 5 people work in one batch and the work is divided into two shifts. 10 people can process more than 20 12-meter-long finished cages in one day Installation of ribs, installation of detection tubes, installation of guide pads, etc.), the work efficiency is very high.
2. During processing, the Bending Center of CNC steel bars strictly prohibits people on one side of the working radius and the body without fixed pins. After the bending steel bars are processed, they should be neatly stacked and the hooks must not face upwards.
3. The workbench and workbench of the bending machine should be kept in a horizontal position. Before operation, the numerically controlled bending center of the core shaft, the forming shaft, the iron guard shaft, and the variable guard should be cracked or damaged. Check that the machine is running properly before processing the rod.
4. During non-replacement of the mandrel and forming the shaft during the cleaning operation, change the angle and speed, fuel or prohibit the bending machine during operation.
5. Familiar with the reverse switch to control the direction of rotation of the forehead of the work board. Rebar should be placed in the direction of rotation of the gears and work plates, and must not be inverted.
6. If the direction of the work plate needs to be changed after stopping, that is, from forward rotation to stop-reverse rotation, it is not allowed to directly rotate from forward rotation to reverse rotation or from reverse rotation to forward rotation.
Please note that the operation of the bending center of the NC steel bar described in the above information, when paying attention to the above problems in use, avoid bending down the CNC steel center, which will affect the use.
