CN
From the Double Wire Straightening Machine Manufacturer, I learned the correct operation rules of the straightener, as follows:
(1) The person must operate the equipment and must prove that it can work.
(2) During the operation of the High-Speed Straightening Cutting Machine, the operator is not allowed to leave the machine too far, and the machine must be turned off while the upper plate, threading is in progress, and the front end is cut off.
(3) In the process of online straightening, when the steel bar jumps out of the tray guide slot, so that the length fixing mechanism cannot be reached and the wire is messed up or the steel bar is out of the rack, the limit switch should be pressed in time to stop cutting the steel bar and wait for the adjustment to operate .
(4) When adjusting the coil of each steel bar to the end or straightening the short steel bar, the steel bar should be escorted to the guide device and the straightening cylinder by the hand shell to avoid injury accidents when moving freely.
(5) Before the straightening mold is fixed and the protective cover is not covered, do not pass through the steel bar to prevent the straightening mold from flying out and hurting people after starting.
(6) During the operation of the machine, the expansion cylinder must not be adjusted. During the operation of the machine, it is strictly forbidden to carry gloves and carry out maintenance work.
(7) Stack the straightened and cut steel bars into small bundles according to specifications and quantity. It is forbidden to pile them up in order to prevent quality accidents caused by the different composition and performance of the steel bars. The power must be cut off after the operation is completed.
(8) Strictly implement the “cross-operation policy” to ensure that the High-Efficiency High-Speed Straightening Machine is in good working condition.
Suppose there is a straightforward safety hazard. For this situation, it should be improved: a bell-shaped inlet tube should be made at the steel bar entrance of the wire straightener, a square tube with certain restrictions should be used, and a frame of appropriate height should be manufactured according to the following requirements: the shape of the bell mouth, its height Suitable for the height of the straightener entrance. The round bar is straightened through the bell mouth and directly enters the wire straightener, which is safe, and reduces damage to the machine, eliminating the possibility that the round bar may cause injury to pedestrians and operators when placing the wire. The rebar straightening process should follow safety regulations to ensure the quality and safety of round steel straightening. In order to ensure the quality of reinforcement engineering, the first step of reinforcement processing should be carefully carried out.
