Welcome to SKZ Intelligent Equipment Co. , Ltd. website!
Industry News
.
Contact Us
Service Line:
+86-18617039171
Email:
info@skz-tech.com
Address:
Room2101, JiaAnDa Mansion, No.110Huafan Rd, Tongsheng Community, Dalang St, LongHua District, ShenZhen, China

The Principle Of Installing Truss Beam Welding Machine

Release Time:2023-04-03 01:26:13Click rate:

The complying with principles shall be adhered to during the installment of Truss Girder Welding Machine:


1. The Truss Girder Welding Machine need to be positioned stably in a well ventilated and also completely dry area, as well as it is not enabled to be near the dangerous environment of high warm, flammability as well as explosion.



2. The Truss Girder Welding Machine made use of outdoors should be shielded from rain and snow.



3. The Truss Girder Welding Machine need to have an unique independent power switch, and also its capacity shall meet the requirements. When the Welding Machine is overwhelmed, it will have the ability to cut off the power instantly. It is forbidden to share one power switch for several welding machines.



4. The power control device shall be installed near the welding machine where it is convenient for manual operation, as well as there will be a risk-free flow around.


Truss Girder Welding Machine


5. The size of the key high-voltage line of the Truss Girder Welding Machine need to not exceed 2-3m as a whole. When a lengthy power line is needed for a short-lived job, it shall be separated as well as organized along the wall surface or column with porcelain bottle, and its height has to be greater than 2.5 jn from the ground, as well as it is not allowed to drag the power line on the ground.



6. The live part of the Truss Girder Welding Machine shall be furnished with undamaged security (seclusion) gadget. The reviewed terminal of the Truss Girder Welding Machine need to be outfitted with a welding machine linked by a safety plug and outlet. The terminal of the pin hole shall be isolated by a protecting dividers and also mounted in the plane of the shielding board.



7. The covering of the Truss Girder Welding Machine must be grounded, and also the grounding gadget need to constantly be well linked. It is forbidden to use flammable and explosive gas pipelines such as oxygen pipes and also acetylene pipes as the natural grounding electrodes of the grounding tool, so as to prevent sparks from detonating as a result of the impact of resistance warm or arc striking existing.



8. When the Truss Girder Welding Machine is attached to the power grid, the voltage of both needs to coincide.



9. After the arc welding generator is attached to the power grid, begin the test run first, as well as observe whether the turning direction of the commutator is consistent with that defined on the welding machine. If it is the opposite, change the setting of any kind of 2 phases in the three-phase power line.



10.the electrical wiring and also installation of the welding machine shall remain in the charge of a special electrical contractor, and the welder shall not do it simply by himself.


If necessary, please contact the Truss Girder Welding Machine Supplier


NEWS